RHD 360 4 branch manifold

[classicswede]

Here you go some pics of the 360 4 branch manifold. Price for one of these would be £300 but can change due to flutuating metal prices

[germ]

Dai that is beutifull, crafted to perfection.

[filthyjohn]

Aye that looks a goodun. It'd be good if they could be produced in large numbers to bring the price down, although it is reasonable considering there must be a good ten hours work in that, plus the cost of stainless tube.

[xtrmjks]

This should be on next week!

[Fuse]

Very nice! Seems to be premium quality.

Now just make also a turbo manifold with a t3 flange and you would have at least 1 customer for those. Turbo manifolds for 300-series are quite hard to come by. Plenty available for 200-series but none for 300-series. And custom mades are like €500 or more so it's almost cheaper to buy an own welder..

[classicswede]

Turbo manifold is quite possible. Would you also need down pipe or just manifold?

[Fuse]

Turbo manifold is quite possible. Would you also need down pipe or just manifold?

I think I'd be able to sort out the downpipe my self, though of course if the price is right I might buy the downpipe too. Though I have the LHD model so I don't know if that makes the planning difficult.

What kind of price range would we be talking with the turbo manifold if you would be able to sort one out?

[classicswede]

I Have talked to him on the price for the turbo manifold and it would come to £350. The extra cost comes from all the extra pre formed elbows required for the tight turns on a turbo manifold. (you can see some bends in in the na one) With the strength of the euro against the pound that should be a good price for you. The down pipe would be best for you to have done to match your existing system.