Page 1 of 1

Questions about Wheel Fitment

Posted: 31 Oct 2010 03:42 pm
by Becca May
Hi everyone :) firstly I apologise if this has been covered before but I couldn't find anything on the search..

Basically i'm just wondering a few things. I know Volkswagen (good because i've owned about 3457880 of them) and Vauxhall (good because the best friend owns a crazily fast Corsa) are the same stud pattern. But what I was thinking was, are there any issues with offsets when swapping wheels from these cars?
I know for the dubs people use Vaux steelies (ET37) for banding because the offset allows for more width of dish, but I don't have a clue regards to Volvos.

I'm mainly wondering because I might be whacking some Vauxhall Fanblades on my Volvo for now. They're ET49 and pretty sure 6J wide.

Cheers in advance 340pw

Re: Questions about Wheel Fitment

Posted: 31 Oct 2010 04:00 pm
by volvosneverdie
Becca May wrote:Hi everyone :) firstly I apologise if this has been covered before but I couldn't find anything on the search..

Basically i'm just wondering a few things. I know Volkswagen (good because i've owned about 3457880 of them) and Vauxhall (good because the best friend owns a crazily fast Corsa) are the same stud pattern. But what I was thinking was, are there any issues with offsets when swapping wheels from these cars?
I know for the dubs people use Vaux steelies (ET37) for banding because the offset allows for more width of dish, but I don't have a clue regards to Volvos.

I'm mainly wondering because I might be whacking some Vauxhall Fanblades on my Volvo for now. They're ET49 and pretty sure 6J wide.

Cheers in advance 340pw
From carlslater.com (IE the bible)

Pcd 4 x 100
ET- 32...38
C.B.- 52.0

Re: Questions about Wheel Fitment

Posted: 31 Oct 2010 04:52 pm
by Speedy88
Anything VW 4x100 is fine, just be prepared to use spacers on the front :wink:

Re: Questions about Wheel Fitment

Posted: 03 Nov 2010 01:20 am
by Becca May
Thanking you :) so to answer my question, if VW wheels require spacers, then Vauxhall wheels definitely will :( bums...

Re: Questions about Wheel Fitment

Posted: 03 Nov 2010 06:57 am
by filthyjohn
I've never needed spacers with any 30-40ET wheels, though I think ET49 may cause a bit of rubbing, perhaps on the rear springs and maybe on lock at the front. Best thing to do is give it a try, I expect SRI fanblades would look awesome.

Re: Questions about Wheel Fitment

Posted: 03 Nov 2010 10:42 am
by Speedy88
Bah I realise now I meant SPIGOT RINGS :roll: :wink:

Re: Questions about Wheel Fitment

Posted: 04 Nov 2010 07:13 am
by filthyjohn
LOLZ. Spigot rings are probably a good idea but I've never bothered with them. Think there used to be a lot on ebay in common size combinations.