exhaust question

Post by **Bilbo** » 17 Sep 2006 07:43 pm

was trying to nip my exhaust clamp up today as it was blowing a little.....1 nut snapped off with little pressure so i left the other nut. its from the middle section to rear joint. does any1 know off the top of their head what size clamp it is so i can pick 1 up tomorrow. it looks about 48mm. its a 360.
ty

Post by **Ali** » 17 Sep 2006 08:10 pm

I'm pretty sure its in the 50's, I'm not sure though as I used flexi-pipe to adapt for my backbox but that was a fairly snug fit over it and don't think its much thicker than normal metal pipe, I measured the outer diameter of it and went to the parts shop, asked for a 56 and they only did 54 or 58 so ended up with a 58. I'd therefore think its more likely to be 52 or 54 at the least as I thought the actual piping was 2" anyway

Post by **Bilbo** » 17 Sep 2006 08:32 pm

thnx
i'll get 2 different sizes just to be on the safe side

Post by **Bilbo** » 20 Sep 2006 04:57 pm

it was 54mm
ty ali

Post by **foggyjames** » 20 Sep 2006 11:00 pm

Yes, they're 50 (or 52...it was two weeks ago!) for backbox and 54 on the mid-pipe.

cheers

James