Remove tailpiece clutchhousing
Remove tailpiece clutchhousing
The splines on the axle of the tailpiece are foobered on my 340 manual. Does anybody know if it's possible to remove the tailpiece without taking out the clutch housing?
Re: Remove tailpiece clutchhousing
Which engine? B172 yes, it is, unless one of the bolts has become unpeened, which you won't find out till after it falls into the abiss.
'89(G) 340 GLE B172k
'03 S60 D5 SE, '91 (J) MX5, 1954 Cyclemaster
Ex:
'89(F) 340 GL F7R (ex B172k) - Fake -> SBKV 300 Runner Up 08, 12; '91(H) 340 GL B14.4E - Kar; '88(F) 360 GLT B200E - Jet -> BKV 300 Runner Up 09; '89(G) 360 GLT B200E - Beast
'03 S60 D5 SE, '91 (J) MX5, 1954 Cyclemaster
Ex:
'89(F) 340 GL F7R (ex B172k) - Fake -> SBKV 300 Runner Up 08, 12; '91(H) 340 GL B14.4E - Kar; '88(F) 360 GLT B200E - Jet -> BKV 300 Runner Up 09; '89(G) 360 GLT B200E - Beast
Re: Remove tailpiece clutchhousing
Yes any 340 in fact (although not sure about auto).
Its called the clutchshaft, just remove the driveshaft then unbolt it, should just slide out with the shaft (also a useful centring tool).
Its called the clutchshaft, just remove the driveshaft then unbolt it, should just slide out with the shaft (also a useful centring tool).
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7