group buy poly bushes

[classicswede]

Just had my wheel bearings collapse the other day, so I decided to change the rear axle. on removing the axle I noticed the top torque are bush had fallen apart(see picture). Also the replacment axle had the same problem. So I had a look at my other scrap cars to find both
of them suffering from the same fault.


As aresult of this I think it would be a good idea to make polyurethane replacment bushes with stainless steel sleeves. They should cost under £15 a pair if enough people put there name down.
I will have to have 50 pairs made. If I get 15 names I will keep the rest as stock.
If I get enough intrest I will look at getting other bushes made.

Thanks

Dai

[bodejodel]

How can I see if they need replacement?

[classicswede]

Try pulling on the bar with your hand if it moves it will need replacing.
If you go to VOLVO you must buy the complete arm!!!!


Dai

[bodejodel]

Thanks, I will chack it out tomorrow...