HELP! CVT clutch shims required

[noo-noo]

Hello All,

I've checked the auto clutch gap and the shims that are currently in there. I measured the clearance gap as 1.2 and I have 2x1.5 (3mm) shims in there at the mo. According to my calculations I need a total of 2.2mm of shimmage in there for a 0.4mm gap? Some guidance says a gap of 2mm + or - 1mm is OK, but to make sure there is no clutch drag it's better to go for 0.4mm min?

If I've worked this out correctly, ideally I need 6x0.5mm shims + 3x1.2mm shims (or something close). If anyone could help I would be very grateful. I think I might be able to get them from Danny in Holland, but thought I'd ask on here first.

I'll make it worth your while

Thanks,

Soph

[noo-noo]

It's OK, I think I've found some

[trabitom99]

I think I might be able to get them from Danny in Holland

... that would have been my first suggestion

Tom

[jimknc_volvo340]

Bump!

Hi all,

Please can you state where you got the shims and CVT clutch from? I think mine have worn and need replacing. Please can you also quote part numbers?

Thanks

Jamie

[trabitom99]

Please can you state where you got the shims and CVT clutch from? I think mine have worn and need replacing. Please can you also quote part numbers?

I think I might be able to get them from Danny in Holland

... that would have been my first suggestion

Tom

http://www.dafhobby.nl

Cheers

Tom

[jimknc_volvo340]

Thanks! appreciate the help.

Jamie