Peco backbox

Post by **Ali** » 30 Jul 2005 05:46 pm

Peco backbox, originally for a Ford Ka but welded 340 backbox mounts onto it so just hangs on the original rubbers, best suited to 1.4 as the bore is similar, would require cutting the original backbox just after the silencer and finding a way to attatch the two together. Theres a decent picture of it in the pictures section under Birmingham meet, can post pictures if anyone is interested, theres a large dent in the can where the Ford Ka was obviously put ontop of another car at the scrappy so more of just a crush than anything else, doesnt affect the workings of it and can't be seen as I made that the top side when welding the mounts on,
cheers
Ali

Post by **foggyjames** » 31 Jul 2005 02:01 pm

What are you asking for it? I need a backbox, but I'm not sure this'll be the right diameter for the 360 exhaust.

cheers

James

Post by **Ali** » 31 Jul 2005 03:59 pm

Nah i'm pretty sure it'll be too small for a 360 James, just been and measured it and its 37mm inlet,
cheers
Ali

Post by **foggyjames** » 31 Jul 2005 10:37 pm

I think the 360 midpipe is 50-60mm...never mind!

cheers

James