econometer fixing..

Post by **redline** » 15 Sep 2005 08:12 am

so basically I tee off the hose that gos to the base of the carb, Kool

Post by **redline** » 01 Nov 2005 03:22 pm

foggyjames wrote:

cheers

James

had a little look around under the bonnet and found the hose to cut (pic 8 above ) but the pipe on the car is a larger bore than the pipe from my econometer ,the only t pieces I have come across so far have all three branches the same size ( windscreen washer jet size ) which is ok for the pipe from the econometer but not the pipe on the car , any suggestions ?

Post by **340GLT** » 01 Nov 2005 07:04 pm

You can get the pipes that step down to the smaller size!! If you want i will get a couple for the meet?
Cheers Adam

Post by **foggyjames** » 03 Nov 2005 12:05 am

redline wrote:the only t pieces I have come across so far have all three branches the same size

The original ones are 'correct' in this way. I think I might have a spare...if not, pull one from any 1.7 - there's one (somewhere else) on every one AFAIK.

cheers

James

Post by **redline** » 03 Nov 2005 09:29 am

yes please Adam , my econometer is permanently in the red ( coz it aint connected )

Post by **thyzerrr** » 03 Nov 2005 10:26 am

Ha, and you think that'll change if you connect it?:lol: