Oh dear... This topic was made for me Mac, expect an order from me

Hi Aymat,

I will have supplies at the BKV (along with RJ and Dai (ClassicSwede) who will have their bits).

Mac.

hi, can you message me a address to post to.. il send a postal order and a list (long) of what i need thanks j

Drive shaft bolts....all of them....now...plz

no i joke but thank god iam on my last 24 and have no more spar can i get a full set of 24 plz

Hi mac was wandering if you do the gasket which goes between the diff and the gearbox? Cheers theo

Hi Theo,

that gasket could well still be available from Volvo, as its a part common to V200s:

http://www.volvo300mania.com/forum-uk/v ... 3&start=28
http://www.skandix.de/en/spare-parts/dr ... n/1032153/

Cheers

Tom

It is, I ordered one along with a input shaft cover gasket from my local volvo dealer a couple of weeks ago

This stuff would be interesting for my race car ...

UPDATE

The speedo drive/hub bearing cap "E" clip is now replaced by the correct OE "eared" KLM clip @ £0.40

I now stock the correct B172 manifold to down pipe studs (M8x42x1.25) with CU flashed self locking nuts @ £1.50 (two studs with nuts).

Mac.

UPDATE

Now stocked,

KLM clip for integral spring retention on B14 throttle cable and adjustment of B172k throttle cable. £0.50

Mac.

Do you make inlet gaskets for a f7p engine?

Do you have the steeringrack bolts and nuts, i just cut the ones of my new racer... now its ziptied dont know if FIA wil allow me to race like that..

I presume you mean the two bolts/nuts through the pinion housing, and the two that secure the saddle (U) clamp on a manual? rack.
Not specifically but I will see if I can match a set from my stock - I will get back to you as soon as I can.

Can't imagine the FIA accepting a rack secured with zipties.

All the best - Mac.

mac wrote: Can't imagine the FIA accepting a rack secured with zipties.

All the best - Mac.

yes that was a joke i need some of those bolts in hard specs, they always go numb

mrborrie - you have been PM'd

Mac.