just wondering if anyone knows if 15x8 inch wheels will fit within stock arches?

the offset is et15, and theyll have 45 profile tyres on, should be the same outer diameter of stock steels, but will they be too wide? both for internal parts (sus etc) and arches?

also should add the car will be lowered 50mm at the rear an 75mm up front, cheer for any help seannaayy

p.s. ive measured myself and they seem to be super close to fitting perfectly, just dont wanna fork out hundreds to find theyll scrub :/

i have 8j wellers with et -10 and stretch tyres and my car is lowerd 1.5inches all round and they rub over big bumps or hard cornering

cheers for the reply mate, have you got any pics please? mine should sit 25mm further under the arch (iirc?) so fingers crossed theyll fit well

thanks again, seannaayy

http://www.driftworks.com/forum/drift-c ... idder.html

thats mine they should fit mate as i say its only over big bumps (going abit quick) and hard cornering is when they rub

ahh bugger :/ yours are 13s, i was looking at 15s! so think ill rule them out now as itll look majorley out of proportion, im thinking 14 x 7s now haha cheers for the info mate, much appreciated!!

seannaayy

8x14 with 195/45/14 tyres on

ATS cups will fit nicely although most are 7J, you can get some in 8

ahh cheers guys

attack2001, dont suppose you know the offset of those wheels do you? cant quite see what they are , and im guessing thats lower than 50mm blocks and 75mm springs? or so i hope haha ill be lowering my 340 this weekend so can check measurements.

and yeah speedy88 they do look nice tbf, but wanna try someting new and different on mine

cheers again guys, any more help is much appreciated
seannaayy

This is the original for sale thread for the purple one is here: http://www.driftworks.com/forum/drift-c ... orque.html

It doesnt say what offset they are, but it does say that its on leafs at the back and coilovers at the front Thomas.....................