what do you think?

Post by **bennett** » 15 Feb 2006 09:21 pm

lowererd 80mm and fitted me 7x13 running 1705013 what do you think?

Post by **classicswede** » 15 Feb 2006 09:32 pm

Did it drop that much?

Post by **SteveP** » 15 Feb 2006 09:34 pm

Looks good... I think I'd lose the white and try a different colour - but nice stance

Post by **bennett** » 15 Feb 2006 09:56 pm

classicswede wrote:

Did it drop that much?

it dont look like it cause of the small wheels but yes its low.
and thanks will recommend u.

pm me what uprated bushes u do? and can you get them for the gear box? and uprated clutch and brakes? thanks

Post by **classicswede** » 15 Feb 2006 10:26 pm

I do the wishbone bushes anti roll bar to body bushes and uprated anti roll bar link rods.
The clutch is a bit of a problem as no one makes one as far as I know.

Post by **bennett** » 15 Feb 2006 10:31 pm

do any reno cluth plates fit?

Post by **classicswede** » 15 Feb 2006 10:39 pm

No non of them fit

Post by **340 Nate** » 15 Feb 2006 10:55 pm

was it lowered 80mm at the rear aswell?

cheers

Nate

Post by **bennett** » 15 Feb 2006 11:19 pm

yes thanks to parts from classicwede

Post by **340 Nate** » 16 Feb 2006 12:06 am

stunned

, i'll be in touch soon classicswede if you want some bits n bobs sold

cheers

Nate

Post by **sven360** » 16 Feb 2006 12:08 am

nice rims

What width and how many beer tokens to prise them from ya?

Post by **340GLT** » 16 Feb 2006 01:28 am

Man that thing is Low!!!!
Cheers Adam

Post by **bennett** » 16 Feb 2006 09:47 am

sven360 wrote:nice rims

What width and how many beer tokens to prise them from ya?

the wheels are 7inch wide by 13inch high and it would take 350 for them

Post by **sven360** » 16 Feb 2006 07:41 pm

Too wide for the roady car-need 6's but thanks anyway

What are they by the way?

Post by **Ali** » 16 Feb 2006 08:07 pm

Don't suppose you could measure the ride height from centre of the wheel to the arch?
cheers
Ali