Page 1 of 2
Nearside brake light
Posted: 16 Dec 2004 05:15 pm
by Tom
My passenger side brake light is out. Is it a seperate bulb from the rear headlamp or is it just a buggered fuse somewhere??
Many thanks
Posted: 16 Dec 2004 05:16 pm
by redline
its a twin element bulb isn't it , brake and rear light
Posted: 16 Dec 2004 05:18 pm
by Tom
Ah, right
So it must be a fuse then? Do you know which one it is?
(God, I need to read the manual more!)
Posted: 16 Dec 2004 05:26 pm
by redline
No M8 it could be just one of the elements has gone ,they do that sometimes ,book shows fuse 15 for left hand tail lights if fuse has gone , number plate light on that side will also be out
Posted: 16 Dec 2004 05:28 pm
by redline
sorry brake lights are fuse no12 but your radio and heater blower would be out as well as both brake lights if its the fuse so must be bulb or earth connection
Posted: 16 Dec 2004 05:41 pm
by 5lab
swap the bulb from the other side. easy.
Posted: 16 Dec 2004 07:01 pm
by special
5lab wrote:swap the bulb from the other side. easy.
thats all well and good but then the other side will be out and if my memory serves me right that will still be illigal
tom,
just go and buy a fresh bulb there only a couple of quid
ive got a crack in my drivers side rear cluster i might add some goldfish theres enough water in there!!

Posted: 16 Dec 2004 07:08 pm
by redline
i'd rather have a working offside brake light than nearside anyway
Posted: 16 Dec 2004 07:59 pm
by 5lab
it would be illigal but it would proove it is the bulb!
Posted: 16 Dec 2004 08:12 pm
by DeKayDAD
Are you lot taking the mick.Just put a new bulb in.
Posted: 16 Dec 2004 10:38 pm
by redline
Sorry dad
Posted: 16 Dec 2004 10:48 pm
by DeKayDAD
your making me feel old...........Am I sounding old
Posted: 16 Dec 2004 11:11 pm
by redline
No your not old but i'm only 45
Posted: 17 Dec 2004 06:03 pm
by Tom
Right. Bought a new bulb today and fitted it according to the manual but it still didn't work. So then I replaced the fuse with the spare one in the fuse compartment (which has never been used) and this was also to no avail.
Wiring problem perhaps??
Posted: 17 Dec 2004 06:13 pm
by 5lab
chances are the pins arent lined up for the bulb, make sure each 'leg' has a contact