went to my local scrappy today, wasnt much there tbh. then as i was walking away, out of the corner of my eye, saw a rather boxy looking car, turned out to be a volvo.

popped the bonnet, found a rather tasty looking redblock B200FT under the bonnet.

would i be correct in thinking they are a direct fit in a 360? but not so in a 340? what would i need? the bell housing from a 360? mounts? didnt have much time to look but are they still carb on them? what turbo? how much boost is run?

if it is a pig to fit, is there any bits i could take off it and put in my b172? like the cams or carb? the vehicle in question is a j reg 940

http://www.volvo300mania.com/forum-uk/v ... 83&start=0

think thats been covered before dude.
If its a 340 youd be better off with a renault engine.

Have a read through that thread man.

tut, had a feeling it was 360 only. lol. guess the cam and carb wont be any good either then?

monka wrote:tut, had a feeling it was 360 only. lol. guess the cam and carb wont be any good either then?

fraid not.
If you can get it cheap, sell it on then you might get some pennies toward a nice 1.8 turbo or a valver.

Cam and carb? FIrst of all the 940 is fuel injected... secondly the cam in standard B200FT's is a 'T' cam and it's rubbish, you might as well be driving a diesel