In bolton looking for front wheelbearings. Also a LOT of parts needed tat arent important but I do want them....

Rear bumper.
Drivers door, driver side rear door, interior Door handles, interior door lever surround, (the square plastic thing that is easy to snap), original volvo rear speakers - that's about everything, If poss need Green Metallic body panels - Big job, this is going to be my European cruiser

Haynes.Volvo workshop manual???? would be invaluable at this point, need to do 60k service!

The wheel bearing you should be able to get from a good motor factors. The front wheel bearings are the same on all models, from around 83 on. As for rear bumper is yours bent or is the outer plastic damaged? I have a good bumper cover but no beam (reinforcement)
I also will have all the otehr parts except for the doors, i do have some doors here but they arent amazing and are mettalic blue.
Adam

The bumper has holes drilled in it for reg plate lights, along the top. (not my handywork... my work either shines or spins freely... this "hole" creation is a new one for me)

Are the doors u have VERY rusted/dented, my back door has a fair bit of rot and front door has a huge scratch and dent - Thinking about it I might just cut a piece out of the back door, only 2" square that's rusted.


SCRATCH! - methinksI best get the camera out and post some photo's of whats snapped and what's fell off/been broken off so far. Photo's to follow.