f7r\p backwards manifold

[tattooer]

going bike carbs so not needed, done to a very high standard,
140ono item in chatham kent pick up ideally 07936384390 jake-

[tattooer]

must be abit pricey? 120ono...

[Chris_C]

Got a picture? Cut and welded on the flange or cut the end off one side and put it on the other?

[theo2468]

Yeah how well has it been done? I'm sure speedys manifold was the problem of his running

[Speedy88]

Nah my running problem was due to a loom problem with the intake temp sensor. Adam swore by the design, not to mention he had it running perfectly for years before it went into my car.

[bmiles]

The welds look like been done by a pro .

[tattooer]

Will get pic asap. But it no messabout. The welds are perfect !

[filthyjohn]

I don't think people are asking about the quality of the welds, I think they're asking where on the manifold they are, four of them on the inlet runners or one big one after the throttle body?

[Chris_C]

I don't think people are asking about the quality of the welds, I think they're asking where on the manifold they are, four of them on the inlet runners or one big one after the throttle body?

Much better put than I managed!

[classicswede]

From memory I think the manifolds Adam had done were with the throttle plate cut and welded onto other end rather the cut on the runners.

[bmiles]

That how this one has been done