Last few questions I have about the conversion
What throttle cable is used on the non flipped mani?
Isit just a case of plumbing up a fuel pump or do I have to take the one out of the fuel tank?

Make one from your old cable. You just need the bulkhead bracket and bike bits.

I doubt you currently have a pump in the fuel tank? I run an Evo one in tank.

Didn't think I woul have anything in the tank was just checking
I have a 1.4 throttle cable so what parts do I need? What bike cable?

He means a bicycle gear/brake cable. Just mock one up when you've got the engine in for test fitting.

Oh and you'll need to know that when you use a fuel pump, you'll need a regulator set to 3 bar.

a bike gear cable of what?
and im using the fuel pump of the old car so should be fine that never had an issue touch wood

samueljon wrote:a bike gear cable of what?
and im using the fuel pump of the old car so should be fine that never had an issue touch wood

From a bike with gears
The valver needs more fuel than your old car's engine, so you should get a better one

Ah no vermilion, he's already got a valver. It's just a shell swap.

ye i am just swapping shells after skillfully writting my old one off

all bikes have gears do they not? pushbike, motorbike? what make? thats what i meant sorry

samueljon wrote:all bikes have gears do they not? pushbike, motorbike? what make? thats what i meant sorry

Dunno if this will help or not, but my Raleigh Ultra-Burner doesnt have any gears.

so i cant get a gear cable off that? damn

samueljon wrote:so i cant get a gear cable off that? damn

Fraid not. If you can find someone breaking a Grifter, youre in!

so what isit you use?
a bike gear cable of what?

samueljon wrote:so what isit you use?
a bike gear cable of what?

Gear and brake cable is pretty much the same on a (peddle) bike isnt it?
I havnt been on for for years thjough so dont take that as gospel.